Table of Contents
Advertisement
AEC-4412B/7412B User's Guide
See Using the Administrator Utility on page 3-4 or Using the Front
Panel Display on page 3-27 depending on which mode you want to
use to configure the AEC-4412B/7412B.
See LED Status Lights on page 3-28 for information on the front panel
LEDs.
Switching Between the Administrator Utility and
the Front Panel Display Menus
The AEC-4412B/7412B is initially set to use the front panel display
to configure the controller. You can switch back and forth if you
want. The following sections describe how to change between the
two different modes.
Running the Administrator Utility
To switch from the front panel display to the Administrator Utility,
follow these steps:
1
Make sure the controller is connected to a VT100 or ANSI ter-
minal through a serial RS-232 interface.
2
Reboot the controller and hold down the spacebar on the
terminal.
The BFLU menu appears.
3
Select Run Bridge from the menu options.
The Administrator Utility appears on the terminal.
Running the Front Panel Display
By default, the AEC-4412B/7412B is initially set to use the front
panel display. If you switched to running the Administrator Utility,
you can switch back to using the front panel display by following
these steps:
1
Reboot the controller and hold down the Select button on the
front panel.
The BFLU menu appears in the front panel display.
2
Use the
or
buttons until you see the Run Bridge menu
option.
3-2
AEC-4412B/7412B User's Guide
Stock Number: 511640-00 Rev B
Print Spec Number: 497358-00
Current Date: 3/19/98
Page: 3-2
ECN Date: 3/20/98
Advertisement
Table of Contents
