Acu Error Codes - Adaptec 2025ZCR Installation And User Manual

ACU Error Codes

When the ACU detects an error, it reports the error and exits
immediately. If a log file is specified, the ACU writes the error code
to the log file. Otherwise, it displays the error code on the screen.
The possible error messages returned by the ACU are listed in the
table below.
ACU Error Codes
Code Description
0 ACU ran without changes—The ACU exited with no errors
(success) and no report is required.
1 No controller found—The ACU did not detect any controllers in the
system.
2 Syntax or logical error in the script file—The ACU encountered an
invalid command or keyword in the specified script file.
3 Unable to open file—The ACU was unable to open the specified
script or log file.
4 Error in the command line parameters—You passed an invalid
command-line switch to the ACU. (See
Scripts on page B-3
5 Unable to read system configuration—The ACU was unable to get
the configuration information from the specified controller.
6 No drives detected—The ACU did not detect any devices attached
to the selected controller.
7 Specified drive not found in system—The device you specified
does not exist on the selected controller.
8 Specified array size too small—You specified an array size that is
smaller than the minimum size allowed for this array.
9 Specified array size too big—You specified an array size that is
larger than the maximum size allowed for this array.
10 Number of drives do not match the array type—The number of
drives you selected is invalid for the type of array specified.
11 Unable to initialize drive—The ACU was unable to initialize one or
more devices.
12 Error occurred while creating array—The ACU encountered an
error creating an array.
13 Too many spare drives assigned—You attempted to assign more
than the maximum number of hotspares allowed for the specified
array.
for the list of valid command-line switches.)
Running the ACU Using
ACU for DOS
B-13