Disk Commands - Adaptec 2025ZCR Installation And User Manual

controller set container_verify [/verify_enabled={boolean}]
Turns the container verify task on or off.
Switches
/verify_enabled—Specifies whether to turn on or off the
container verify feature. The default is TRUE, which means the
command turns on the container verify feature.
controller show automatic_failover
Displays the automatic failover status (enabled or disabled) for
the controller.
controller show channels
Displays all of the channels on the controller with the
characteristics of each channel.
controller show container_verify
Displays the status of the container verify status.

Disk Commands

Use the disk commands to manage disks connected to a RAID
controller. The CLI allows you to monitor disk characteristics and
parameters, prepare a disk for use, and detect defects.
disk blink {device_ID} {integer}
Causes the disk access light to blink.
Parameters
{device_ID}—ID number of the device to blink.
{integer}—Number of seconds for the disk to blink. A value of
zero stops the blinking.
disk initialize [/always={boolean}]
[/unconditional={boolean}] {device_ID}
Initializes a disk on the currently opened controller.
Parameters
{device_ID}—ID number of the device to initialize,
Command Line Interface
D-28