Table of Contents
Advertisement
Adaptec ATA RAID 1200A Installation and User's Guide
Create JBOD (Volume) Array
To create a JBOD array, follow these steps:
1 From the Main menu Menu bar, select
Configuration>Create>JBOD (Volume)
or, from the Main menu toolbar, select JBOD.
2 From the Available Disks screen, select the disk, then click Add.
Note: You must have at least two hard disk drives to create a
JBOD array.
3 Specify an array name of eight characters or less. If you don't
specify an array name, one will be automatically created. Click
Next. A list of disks will be displayed.
4 Click Create. The following message appears:
All data on the selected disks will be deleted! Are you sure you
want to continue?
Click Yes to continue.
5 You will get a confirmation message notifying you that the
RAID you specified has been created successfully. You will be
prompted to restart your system. Click Yes to restart. After you
have restarted your system, the Main menu will display your
built arrays.
View the Event Log
The Event Log is a file used to maintain information about prior
controller activities or errors. To view the Event Log, follow these
steps:
1 On the Main menu, select View log from the toolbar.
You will get a display of the type of event, the time it occurred,
and a description of the event.
5-12
Advertisement
Table of Contents
