Connecting ATA Disk Drives to the Adaptec ATA RAID 1200A
Card
Connect all hard disk drives to the Adaptec ATA RAID 1200A card
using the 40-pin ATA/100 cables included in your kit. The
ATA/100 cables have the following color-coded connectors:
Blue—Connects to the controller
Black—Connects to the master or single drive
Gray—Connects to the slave or second drive.
Note: Although the master/slave configuration is
determined by the jumper settings on your hard disk drives,
Adaptec recommends you use this color-coded
configuration for the cable. See
Drives on page 2-5
Blue Connector
Figure 2-5 40-pin ATA/100 Cable
Setting Jumpers on ATA Disk
for more information.
Gray Connector
Installing the Hardware
Black Connector
2-7