Terminating A Task - Adaptec DuraStor 7220SS User Manual

Adaptec Storage Manager Pro for DuraStor User's Guide
After the task is complete, its information disappears from the
Tasks tab. See Understanding the Details Pane Status Column on
page 6-7.
Note: When you create a redundant array (mirror set [RAID
1], RAID 3 set, RAID 4 set, RAID 5 set, stripe set of mirror
sets [RAID 0/1], or stripe set of RAID 5 sets [RAID 0/5]),
Storage Manager Pro performs a Build task after it creates
the array. The progress of the Build task appears in the
Task tab.

Terminating a Task

You can terminate some tasks in Storage Manager Pro at any time.
Some tasks take only a few seconds or less to complete and do not
last long enough to permit termination.
If you terminate the Build task, the array exists but may not be
usable. To make the array usable, you need to delete the array and
re-create it.
Caution: You risk losing data if you terminate a Build task.
!
To terminate a task:
1 In the System Browser window, select the array, disk drive, or
other device that is affected by the task.
2 In the Details pane, click the Tasks tab.
3 Select the task that you want to terminate.
4 Click Terminate.
The task stops running.
6-6