EMC Connectrix B Series Hardware Reference Manual page 37

Table 1
LED name LED color
Power Status No light
Steady green
System Status No light
Steady green
Steady amber (for
more than five
seconds)
Flashing
amber/green
Ethernet Speed No light
Steady green
Ethernet Link No light
Steady amber
Flashing amber/no
light
Table 1 describes the LEDs and their actions on the port side of the
switch.
Port side LED patterns during normal operation (1 of 2)
Status of hardware
System is off or there is an internal
power supply failure.
System is on and power supplies are
functioning properly.
System is off or there is no power.
System is on and functioning properly.
Unknown state, boot failed, or the
system is faulty.
This LED displays steady amber during
POST, this is normal and does not
indicate a fault.
Attention is required. A number of
variables can cause this status including
a single power supply failure, a fan
failure, or one or more environmental
ranges has exceeded.
Port speed is 10 Mb/sec.
Port speed is 100 Mb/sec.
There is no link.
There is a link.
There is link activity (traffic).
Operating the DS-5300B
Recomended action
Verify that system is powered on (power
supply switches to "1"), the power cables
attached, and your power source is live.
If the system power LED is not green,
the unit may be faulty.
Contact your EMC Customer Service
representative..
No action required.
Verify that system is on and has
completed booting.
No action required.
Perform the following steps:
Connect a serial cable to the system.
Reboot the system.
Check the failure indicated on the
system console.
Contact your Contact your EMC
Customer Service representative.
Check the management interface and
the error log for details on the cause of
status.
Contact your Contact your EMC
Customer Service representative.
No action required.
No action required.
Verify that the Ethernet cable is
connected correctly.
No action required.
No action required.
Interpreting LED activity 37