Manitowoc GROVE 5540F Operator's Manual page 41

5540F/YB5515 OPERATOR'S MANUAL
Overload less than 25%
1 Lift Cylinder Inspect for leaking.
2 Wire Rope Inspect all for damage.
Turntable
3 Check bolts for proper torque.
Bearing
Overload from 25% to 49%
1 Lift Cylinder Inspect for leaking.
2 Wire Rope Inspect all for damage.
Turntable
3 Check bolts for proper torque.
Bearing
4 Hoist/Drums Inspect each for damage.
5 Hoist Brakes Brakes must hold rated line pull.
Bearing Main
6 Boom Pivot Inspect for deformation, cracked welds.
Pin
Lift Cylinder-
7 Inspect pin and welds.
Lower Mount
8 Turret Area Inspect for deformation, cracked welds.
Mounting
9 Check bolts for proper torque.
Studs
10 Welds Inspect for cracks.
Inspect for cracked paint which could indicate twisted,
11 Paint
stretched, or compressed members.
GROVE
Published 10-21-2011, Control # 055-03
SAFETY INFORMATION
See topic in Introduction section
of Service Manual.
See topic in Swing section of
Service Manual.
See topic in Introduction section
of Service Manual.
See topic in Swing section of
Service Manual.
2
2-27