Mercedes-Benz AMG GT Operator's Manual page 306

304 Wheels and tires
and one-half times as well on the government
test track as a tire graded 100.
The relative performance of tires depends upon
the actual conditions of their use, however, and
may depart significantly from the norm due to
variations in driving habits, service practices and
differences in road characteristics and climate
conditions.
Traction grade
& DANGER Risk of accident due to inade‐
quate traction
The traction grade assigned to this tire is
based on straight-ahead braking traction
tests, and does not include either accelera‐
tion, cornering, hydroplaning or peak traction
characteristics.
Always adapt your driving style and
#
drive at a speed to suit the prevailing
traffic and weather conditions.
* NOTE Damage to the drivetrain from
wheelspin
Avoid wheelspin.
#
The traction classes, from highest to lowest, are
AA, A, B and C. Those grades represent the tire's
ability to stop on wet pavement as measured
under controlled conditions on specified govern‐
ment test surfaces of asphalt and concrete. A
tire marked C may have poor traction perform‐
ance.
Temperature grade
& WARNING Risk of accident from tire
overheating and tire failure
The temperature grade for this tire is estab‐
lished for a tire that is properly inflated and
not overloaded. Excessive speed, underinfla‐
tion, or excessive loading, either separately
or in combination, can cause excessive heat
build-up and possible tire failure.
Observe the recommended tire pres‐
#
sures and regularly check the tire pres‐
sure of all tires including the spare
wheel.
Adjust the tire pressure as necessary.
#
The temperature grades are A (the highest), B
and C. They represent the tire's resistance to the
generation of heat and its ability to dissipate
heat when tested under controlled conditions on
a specified indoor laboratory test wheel. Sus‐
tained high temperature can cause the material
of the tire to degenerate and reduce tire life, and
excessive temperature can lead to sudden tire
failure. Grade C corresponds to a level of per‐
formance which all passenger car tires must
meet under the Federal Motor Safety Standard
No. 109. Grades B and A represent higher levels
of performance on the laboratory test wheel
than the minimum required by law.
DOT, Tire Identification Number (TIN)
US tire regulations stipulate that every tire man‐
ufacturer or retreader must imprint a TIN in or
on the side wall of each tire produced.