Table of Contents
Advertisement
9. Using the screws supplied with the cable, attach the end of the cable with the
connector to the rear of the chassis. Attach the other end of the cable to the
external SAS connector on the system board.
10. Install the air baffle (see "Installing the air baffle" on page 112); then, route the
cable through the slot in the side of the air baffle.
The following illustration shows the routing for the external SAS cable.
Important: Make sure the SAS cable doesn't interfere with an adapter
installed in the riser-card assembly.
Riser card assembly
Release tab
Air baffle
Chapter 5. Removing and replacing server components
External SAS cable slot
External SAS cable
117
Advertisement
Table of Contents
