Installing The Cd/Dvd Media Backplane - IBM 7985 Problem Determination And Service Manual

Installing the CD/DVD media backplane

To install the replacement CD/DVD media backplane, complete the following steps.
10. Turn on all attached devices and the server.
CD/DVD media backplane
1. Align the CD/DVD media backplane at the rear of the CD/DVD bay.
2. Install the two screws that secure the media backplane to the chassis.
3. Connect the CD/DVD power and signal cables to the two connectors on the
media backplane.
4. Connect the operator-information-panel cable to the connector on the system
board (J76) (see "System-board internal connectors on page 11 for the
location of the connector).
5. Slide the CD-RW/DVD drive into the bay until it clicks (see "Installing a
CD-RW/DVD drive" on page 126).
6. Install the fan-bracket assembly (see "Installing the fan-bracket assembly" on
page 137).
7. Install the cover (see "Installing the cover" on page 110).
8. Slide the server into the rack.
9. Connect the cables and power cords.
Chapter 5. Removing and replacing server components
151