G) Attaching And Fastening The Car Body; H) Controlling The Vehicle - Reely ROAD Carbon Fighter Operating Instructions Manual

g) Attaching and Fastening the Car Body

Push the aerial tube from the bottom of the body through the respective opening. Now put the car body on the holders
and fasten it with the car body clips removed at the start.

h) Controlling the Vehicle

Operate the throttle/braking lever for the drive function at the transmitter very cautiously and do not drive
too fast at the beginning until you get used to the reactions of the car. Do not make any quick or jerky
movements with the operating elements of the remote control.
If the vehicle shows a tendency to pull towards the left or the right, set the steering trim on the transmitter accordingly.
When switching between forward and reverse gears, the throttle/brake lever must be put in neutral position briefly
(neutral position = let go of lever, do not move it). If the throttle/brake lever is moved from forward to reverse directly,
the brake function of the drive is activated (vehicle will NOT reverse!).
The figures below only serve to illustrate the functions; they do not have to correspond to the design of the included
transmitter!
1. Release throttle/braking lever, vehicle rolls to a halt (or does not move, if required, correct trimming), lever is in
neutral position
2. Drive forward, slowly pull the throttle/brake lever towards the handle
3. Drive forwards and then brake (vehicle slows down; does not roll to a halt slowly); push throttle/brake lever away
from the handle without stopping.
4. Drive forwards and then backwards (wait briefly between changes and leave the lever in its neutral position!).
40
Wait briefly