CC-Link interface module
Figure 10:
Station number setting
switches
4.5 First configuration steps
This chapter describes the basic steps you have to perform for the configuration of
the CC-Link interface module:
Station number configuration
Establish a first connection between the MELSEC-WS safety controller and a PC
or notebook.
Configuration of the number of occupied stations
Upload or transfer of a configuration
Verification of a configuration
4.5.1
Station number configuration
Configure the station number of the CC-Link interface module.
Since the configured station number becomes valid when the module is powered on,
power off the module before configuration.
The following is an example when the station number is set to "11".
MELSEC-WS
26