Default Settings For The Output Data Set - Mitsubishi Electric MELSEC WS Series User Manual

MELSEC-WS
Table 11:
Default configuration for
the output data set
41

5.5 Default settings for the output data set

In the delivery status, the output data set (RY, RWw) of the CC-Link interface module
are pre-configured. The following table shows the default data assignment.
The "reserved" areas shown in the following table are for system use; therefore,
these areas are not displayed on the editing window.
One station is
Data
occupied.
RY07 - RY00 Byte 0
RY0F - RY08 Byte 1
RY17 - RY10
Use prohibited
RY1F - RY18
RY27 - RY20
RY2F - RY28
RY37 - RY30
RY3F - RY38
RY47 - RY40
RY4F - RY48
RY57 - RY50
RY5F - RY58
RY67 - RY60
RY6F - RY68
RY77 - RY70
RY7F - RY78
Two stations are Three stations
occupied. are occupied.
Byte 0
Byte 1
Byte 2
Byte 3
-
-
Use prohibited
Use prohibited
Data sets
Four stations
are occupied.
Byte 0 Byte 0
Byte 1 Byte 1
Byte 2 Byte 2
Byte 3 Byte 3
- --
- -
- -
- -
- -
- -
-
-
-
-
Use prohibited
-: Not configured