MELSEC-WS
Figure 15:
MELSEC-WS to CC-Link
dialog of the WS0-GCC1
37
5.4 Customizing the input data set
(MELSEC-WS to CC-Link)
This section outlines briefly how you can customize the input data set that the CC-
Link interface module transmits to the network.
In the delivery status, the data routing configuration of the CC-Link interface module
is shown in the network module configuration dialog.
Click on the GCC1 Network module [13] button (Network Modules button
when two network modules are used) above the main window and select the
desired CC-Link interface module or double click the desired CC-Link interface
module in the hardware configuration to open the network module configuration
dialog.
Click on the MELSEC-WS to CC-Link tab on the left hand menu to display the
network module configuration dialog.
The default setting is as follows:
Basically this dialog is divided into three areas: Available data (1)), Network
Module Data (2)) and Tag names (3)). The upper left corner of the dialog holds the
toolbar (4)).
Data sets