System Connection Example; S-Bus Control System Connection Example - Sony BKS-R3219A Installation And Setup Manual

1-6. System Connection Example

1-6-1. S-BUS Control System Connection Example

The connection example of the S-BUS data link using the IXS-6700 as the primary station is shown.
Terminal
Personal computer
(Terminal emulator)
Primary
Level 1
station
Integrated
routing system
IXS-6700
Secondary
station
Source
VTR
Maximum
128
equipment
Either one of the REMOTE 1 connectors of the secondary station routing switchers can be used.
*1 : (S) indicates the secondary station. For the secondary stations, set the station ID in the range of ID = 2 to 254 in the manner that the
same ID must not be duplicated.
*2 : Install the 75 Z terminators to the T-type bridge or Y-type bridge of the last device on the S-BUS data link and to the unused
REMOTE 1 connector.
1-8
Maximum
16 equipment
Terminal
NETWORK A
NETWORK B
( P )
Level 2 Level 3
Audio
routing switcher
routing switcher
*1
( S )
Audio
Channel 1/2
Audio
Channel 3/4
Subnet Controller
REMOTE1 A
Remote
control panel
BKS-R6010
Subnet Controller
Remote
control panel
BKS-R3219A
Remote
control panel
BKS-R1617A
Personal computer
(Terminal emulator)
Ethernet
Switch
Video
Audio channel 1/2
Audio channel 3/4
Level 4
Audio Time code
routing switcher
*1 *1
( S ) ( S )
Time code
Tertiary station
REMOTE1 A
Remote
control panel
BKS-R6010
Remote
control panel
BKS-R1617A
: S-BUS
: Signal system line
: Ethernet
: T-type bridge (A)
: T-type bridge (B)
*2
: 75 Z terminator
: Layer of matrix
Destination
VTR
Time code
Level 8
Each
routing switcher
*1
( S )
Display unit
Display unit
Display unit
Display unit
BKS-R3219A/R1617A I&SSM