Table of Contents
Advertisement
2-10-2. How to Attach the Key Label
Attach the key labels to the buttons with the following
procedure.
Required tool
Key-cap puller: Part number 3-179-054-02
1. Remove the button by inserting the tips of the tool in
the grooves along the sides of the button.
2. Remove the internal cap by holding the grooves of the
internal cap in the removed button with the tips of the
tool and slightly bending the internal cap.
3. Attach a key label and install the internal cap.
4. Install the button in the original location.
2-8
Key-cap puller
Key-cap puller
2-11. Settings by Using the Buttons
(Setup Function)
2-11-1. Setting the Station Number
Set the station number using the source/destination select
buttons 1 to 8. The station number is obtained by adding
the binary place values of the buttons that are lit. For
example, if the buttons 1, 2 and 4 are lit as shown below,
the station number is 11 (= 1 + 2 + 8).
1
2
3
Not lit (OFF)
0
0
0
Lit (ON)
1
2
4
Examples of
1
2
3
setting a station
number 11
1 +
2
+
0
n
Do not assign the same number to more than one unit in a
routing system.
1. Press and hold the LOCK (CHOP) and PROT buttons
for about 5 seconds to reset the software.
2. Press and hold the source/destination select buttons 1,
2, 3, and 4 during being rebooted to enter station
number setting mode.
n
When the power is turned ON for the first time, station
number setting mode is automatically set, and steps 1
and 2 are not required.
3. Press the appropriate source/destination select buttons
so that the desired station number is obtained.
4. Press the LOCK (CHOP) button.
The set station number is registered.
4
5
6
7
8
0
0
0
0
0
8
16
32
64 128
4
5
6
7
8
+
8
+
0
+
0
+
0
+
0
=
BKS-R3219A/R1617A I&SSM
11
Advertisement
Table of Contents
