Relationship With Z: Set Panel Status Setting Items; Restrictions - Sony BKS-R3219A Installation And Setup Manual

5-1-3. Relationship With Z: SET PANEL
STATUS Setting Items
Route Change
Normal route function will issue the switch command to
the downstream Switcher 2 at the same time when the
switch command is issued for the upstream Switcher 1, but
this function will stop the issuing of the switch command
for downstream Switcher 2 when it is set to disable.
n
Refer to Section "3-4 Secondary Station Menu" "Z: SET
PANEL STATUS" ROUTE CHANGE Item for descrip-
tion on contents of setting.

5-1-4. Restrictions

1. Multistage Connection of Route Setting
Route setting is possible to set in multistage as following.
INA
OUTA
LVA INB
OUTB
LVB
INC
LVC
Route Dest
Route1 OUTA
Route2 OUTB
Route3 OUTC
Route4 OUTD
Fig. 9 Route Multistage Setting
Up to 5 stages is possible for route setting as in figure.
Deployment of cross-point over 5 stages or displaying of
source going over 5 stages for status display will not be
done.
BKS-R3219A/R1617A I&SSM
OUTC
IND
OUTD
LVD
INE
OUTE
LVE
Dest Src Lv
OUTB INB LVA
OUTC INC LVB
OUTD IND LVC
OUTE INE LVD
2. Invalidity of Sharing Route Trunk
Same route trunk cannot be used by multiple route settings
when the route setting is set.
INA
OUTA
Route Dest
Route1 OUTA
Route2 OUTA
Fig. 10 Impossible Setting Sharing Same Route Trunk
It is possible to share the trunk by using the simplified
Destination Offset.
Refer to Section "5-1-2 Example of Using Route Function."
INB
Level
Dest Src Lv
OUTB INB Level
OUTC INB Level
OUTB
OUTC
5-5