Grandstream Networks GRP2601 Administration Manual page 69

Web Access
Configures the HTTP port under the HTTP web access mode. The valid range
HTTP Web Port
is 80 – 65535. The default value is "80".
Configures the HTTPS port under the HTTPS web access mode. The valid
HTTPS Web Port
range is 443 – 65535. The default setting is "443".
Sets the protocol for web interface.
Web Access Mode
The default setting is "HTTP".
Web Access Control Web access control by using Whitelist or Blacklist on incoming IP addresses
Web Access Control Only allow the IP address list as a whitelist or restrict the IP address list as a
List blacklist to access the Web.
Web Session Configures timer to logout web session during idle. The valid range is 2-60 min.
Timeout The default value is 10 min
Enable User Web Administrator can disable or enable user web access. The default setting is
Access "Enabled".
After enabling this feature, phone will validate the server's certificate. If the
Validate Server
server that our phone tries to register on is not on our list, it will not allow server
Certificates
to access the phone.
Specifies the time in minutes that the web or LCD login interface will be locked
Web/Restrict mode out to user after five login failures. This lockout time is used for web login, and
Lockout Duration LCD restrict mode admin login. Range is 0-60 minutes. The default setting is
"5".
Web/Restrict Mode
lockout Attempt Configure attempt limit before lockout. Default is 5. Range is 1-10.
Limit
User Info Management
User Password
New Password Set new password for web GUI access as User. This field is case sensitive.
Confirm Password Enter the new User password again to confirm.
Admin Password
Current Password
The current admin password is required for setting a new admin password.
•
HTTPS
•
HTTP
•
Disabled
•
Both HTTP and HTTPS
GRP260x Administration Guide
Version 1.0.1.18
P a g e | 69