Removing The Broil Burner Assembly - LG LDG4313BD Service Manual

REMOVING THE BROIL BURNER ASSEMBLY

WARNING
• DISCONNECT power supply cord
from the outlet before servicing.
• Replace all panels and parts before
operating.
• RECONNECT all grounding devices.
- Failure to do so can result in severe personal
injury, death or electric shock.
• Make sure the igniter connector is
completely outside when reinstalling
the broil burner assembly.
CAUTION
• Use caution when handling sheet
metal parts while servicing the
range.
- Some parts may have sharp edges, which
could result in injury.
1. Turn off the electrical supply and gas supply
going to the range.
2. Remove the upper oven door and remove the
racks from inside the oven.
3. Remove the rear back cover, and motor cover :
(see step 2,4,5 on page 3-2).
4. Disconnect the igniter plug.
4 screws
COMPONENT ACCESS
(For the Upper oven only)
3-11
5. To remove the broil burner assembly:
a) Remove the back cover by removing the
screw.
b) Remove the 3 screws in the order for easily
removing.
c) Remove 1 screw from the igniter bracket.
d) Remove the igniter connector in the cavity
(To get the connector, pull the wire toward the
cavity).
e) Remove the broil burner assembly.
Screw + Washer
Screw (2ea)
NOTE : When removing the screws, make sure
holding the : broil burner assembly.
6. To remove the igniter:
a) Perform step 1-5 on this page.
b) Remove the 2 screws and then remove the
igniter.
Igniter bracket
Screw (2ea)