Master Unit; Slave Unit - Hayward AquaRite+ AU Master Installation And Setup

The use of a Master and Slave AquaRite+ AU setup allows the system to better meet the chlorine demand requirements
of the pool. It is ideal in pools that exceed 150,000 litres in cool climates and 110,000 litres in tropical climates. By
controlling one AquaRite+ AU unit with another, the first unit acts as the Master unit and is installed with the pH and ORP
Upgrade Kits, while the second unit acts as the Slave unit and will produce chlorine when instructed to by the Master unit.
In instances where the Master unit cannot keep up with the chlorine demand of the pool, it will signal for the Slave
chlorinatior to be turned on once the ORP level falls to 2% below the ORP/Redox set point. The Slave unit will then begin
to produce chlorine until the ORP/Redox set point has been reached.
NOTE: Before installing this product as part of a salt water purification system in a pool or spa using natural stone for coping or for immediately
adjacent patios/decking, a qualified stone installation specialist should be consulted regarding the appropriate type, installation, sealant (if any) and
maintenance of stone used around a saline pool with an electronic chlorine generator in your particular location and circumstances.
NOTE: The use of dry acid (sodium bisulfate) to adjust pool pH is discouraged especially in arid regions where pool water is subject to excessive
evaporation and is not commonly diluted with fresh water. Dry acid can cause a buildup of by-products that can damage your chlorinator cell.

Master Unit

INTRODUCTION
COMPONENTS
®
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS

Slave Unit

Page 3