Hayward AquaRite+ AU Master Installation And Setup page 10

Configuring Master Unit
1
OK
7
OK
Reset counters
Reset counters Reset counters Reset counters
Filtration Settings for Master and Slave Units
1
OK
NOTE:
-It is recommended that the salinity level for each unit is calibrated to read the same value to limit confusion.
-The temperature reading on each unit should be calibrated to read the same value to limit confusion. If the
Master unit is controlling a heater, ensure that the heater is not running when calibrating the two temperature
readings to be the same. When the heater will be running there will be a differential reading between the two
units due to the different points of measurement in the plumbing.
OPERATION CONTINUED
2
Relay config. Relay config.
Relay config.
Relay config.
OK
Filter pump
Filter pump
Filter pump Filter pump
Extra settings
Extra settings
Extra settings Extra settings
1. Enter System settings from the Main Menu.
8
2. Enter the Service menu from the System Settings.
+
3. Enter the Password:
+
4. Select the Relay config. tab.
5. Scroll down to Redox and select Aux 3.
6. Exit the Relay config. menu and select the Dos. pumps tab in the
7. Select Other pumps.
8. Change the "Pump On" time to 999 minutes and the "Pump Off" time
Master
1. Enter Filtration from the Main Menu.
2
2. Either select the Auto or Smart Mode if the Master unit is not
+
+
3. Set he desired daily run times and schedules for all modes apart
+
+
Slave
1. Enter Filtration from the Main Menu.
2. Set the Slave unit to run in Auto Mode ONLY.
3. If the Master unit is set to operate in Auto, Smart, or Heating
4. If the Master unit is set to operate in Intelligent mode, set the time
USE ONLY HAYWARD
4
Relay config. Relay config.
OK
Filter pump Filter pump
Extra settings Extra settings
Service menu.
to 2 seconds.
controlling a heater and if it is, then Heating or Intelligent Modes can
be selected.
from Intelligent mode that is based on a 24 hour schedule.
modes, set the time schedules on the Slave unit to mirror those of
the Master unit.
schedule of the Slave unit to turn on at 00:01 and off at 23:59
(In this scenario the Slave unit will run a filter pump if connected,
for 24 hours per day). The reason to have the Slave unit standing by
ready to chlorinate for 24 hours, is because the Intelligent Mode that
the Master unit is running, is based on automatic on and off times
and depending on the water temperature, the run times will vary.
®
GENUINE REPLACEMENT PARTS
5
6
+
Reset counters
+
OK
Page 10