Factory Reset (Camera Reset); Save Settings (Save All); Exit Menu (Exit) - Watec WAT-233 User Manual

3.17 Factroy Reset (CAMERA RESET)
This function returns the camera setting to factory default (CAMERA RESET) state. Even after changing camera settings, you can return the camera to the
factory default state by executing camera reset. Move the cursor to CAMERA RESET with UP/DOWN key and press the ENTER to excecute the camera reset.
(3) Move the cursor on CAMERA RESET
and press the ENTER key to execute
CAMERA RESET again.
*When saving the setting value of the factory setting after executing camera reset function, save the value according to 『3.18 Save Settings (SAVE ALL)』.
When the power is turned off without saving the setting value, it returns to the setting value before executing the camera reset.

3.18 Save Settings (SAVE ALL)

Saving (SAVE ALL) the changed camera settings. After changing camera settings, you can save the changed settings by executing
SAVE ALL on the EXIT page. Move the cursor to SAVE ALL with UP / DOWN / LEFT / RIGHT and press ENTER to save the setting
*When you turn off the power or excecute the LOAD operation without saving the setting value after changing, it will return to the state before
the setting change.

3.19 EXIT Menu (EXIT)

Exit the OSD menu. Move the cursor to EXIT with UP / DOWN key and press the ENTER key.
(1) Select the CAMERA RESET and press ENTER Key.
ENTER
(2) After "CAMERA RESET ......" is displayed in screen,
it returns to SETUP MENU 3/3.
ENTER
ENTER
58