Before Use - WilTec 61202 Operation Manual

Before Use

Power Source
Make sure that the power source you are using complies with the requirements on the nameplate.
Grounding
To protect the user from electric shock, this device is grounded during use. The equipment is equipped
with a three-core cable and a grounded plug to allow use of the correct grounding outlet. The green
wire in the cable is the ground wire. Never connect the green (or green and yellow) wire to a live ter -
minal!
On/ Off Switch
The unit's switch must be in the off position when connecting the device to the power supply to pre-
vent accidental starting of the device and the associated risk of injury. To switch the device on, first
press the safety switch (4) and then the on/ off switch. To switch the device off, release the on/ off
switch again. Always hold the demolition hammer with both hands when working.
Extension Cable
If the working area is further away from the power source, use an extension cable with sufficient thick -
ness and rated power. The extension cable must be as short as possible to prevent entanglement.
Refilling of Oil
Before using the device for the firs time, check the oil level and fill the right oil in up to the marked level
(the tank comes pre-filled from the factory with only a small amount of oil).
Changing Attachments
Before assembling or disassembling the tools, make sure that the demolition hammer is switched off
and the electricity plug is disconnected. The tool holder makes it easy and convenient to change tools
without using a key.
Note: For better results, the use of standard attachments is recommended.
1. Turn the handle 180° clockwise as you pull it towards you. Insert the tool shank into the hexagonal
hole (fig. 1).
2. Clamp the tool by turning the handle half a turn in the opposite direction (fig. 2). The tool must be
movable in the holder, but must not be able to be pulled out.
3. To remove the tool, first pull the lock to the back, then the tool can be removed from the holder.
The hammer function causes constant mechanical friction between the tool holder and the tool
shank. Therefore, grease the shank end of the tool regularly with gear grease before inserting it.
Wait until the shank has cooled down after operating the tool. Otherwise there is a danger of being
burnt!
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Artikel 61202 Seite 7
09 2020-1