Advertisement
Quick Links
Operation Manual
Demolition Hammer
61202
Illustration similar, may vary depending on model
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Due to further developments, illustrations, functioning steps and technical data can differ insignificantly.
Updating the documentation
If you have suggestions for improvement or have found any irregularities, please contact us.
Advertisement
Related Manuals for WilTec 61202
Summary of Contents for WilTec 61202
- Page 1 Operation Manual Demolition Hammer 61202 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Due to further developments, illustrations, functioning steps and technical data can differ insignificantly.
- Page 2 All rights re- served. The WilTec Wildanger Technik GmbH cannot be held accountable for any possible mistakes in this operating manual, nor in the diagrams and figures shown.
- Page 3 Never put the demolition hammer out of your hand when it is switched on. • Never point the demolition hammer at a person in the immediate surrounding. The tool can be ejected and cause serious injury. © by WilTec Wildanger Technik GmbH Item 61202 Page 3 http://www.WilTec.de http://www.aoyue.eu...
- Page 4 Product overview № Name Locking mechanism Tool holder Additional handle Safety switch On/off switch Oil tank cover Flat chisel Pointed chisel Wrench Hex wrench © by WilTec Wildanger Technik GmbH Item 61202 Page 4 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
- Page 5 • Chisel (overall length 410 mm) 1× • Oil supply 1× • Hex wrench 2× • Socket wrench 1× Application: Demolition, crushing, and chipping of concrete/brickwork © by WilTec Wildanger Technik GmbH Item 61202 Page 5 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
- Page 6 5. Fill up with oil if the quantity falls below 3 mm. 6. Wear limit 7. Carbon brush number 8. Standard carbon brush 9. Auto stop of the carbon brush © by WilTec Wildanger Technik GmbH Item 61202 Page 6 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
- Page 7 2. Hold the tool firmly with both hands and use the weight of the drill to control the recoil movement. Work at a moderate pace. Too high a speed affects the efficiency. © by WilTec Wildanger Technik GmbH Item 61202 Page 7 http://www.WilTec.de...
- Page 8 4. After prolonged non-use or commissioning at sub-zero temperatures, first allow the demolition hammer to run for a few minutes at idle in order to achieve good distribution of the lubricant in the machine. © by WilTec Wildanger Technik GmbH Item 61202 Page 8 http://www.WilTec.de...
- Page 9 6. If any further maintenance or repair work require the housing to be opened, only have them carried out by a qualified specialist or con- tact an authorized service partner. © by WilTec Wildanger Technik GmbH Item 61202 Page 9 http://www.WilTec.de...
- Page 10 This logo indicates that this electric equipment must not be disposed with the domestic waste. The company WilTec Technik GmbH has been registered in the German registry EAR under the WEEE- registration number DE45283704. Disposal of used electrical and electronic appliances...