Advertisement
Quick Links
Operation Manual
Beading Machine
62053
Illustration similar, may vary depending on model
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Due to further developments, illustrations, functioning steps and technical data can differ insignific -
antly.
Updating the documentation
If you have suggestions for improvement or have found any irregularities, please contact us.
Advertisement
Related Manuals for WilTec 62053
Summary of Contents for WilTec 62053
- Page 1 Operation Manual Beading Machine 62053 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Due to further developments, illustrations, functioning steps and technical data can differ insignific - antly.
- Page 2 All rights reserved. The WilTec Wildanger Technik GmbH cannot be held accountable for any possible mistakes in this operating manual, nor in the diagrams and figures shown.
- Page 3 If any part of the device is damaged, it should not be used any longer. Damaged parts must be properly repaired or replaced before using the beading machine again. © by WilTec Wildanger Technik GmbH Item 62053 Page 3 http://www.WilTec.de...
- Page 4 Use soap and water to clean coloured parts or plastic/rubber parts. After cleaning, cover all exposed surfaces with a light layer of oil. Warning! Do not use flammable detergents to avoid a possible fire hazard. © by WilTec Wildanger Technik GmbH Item 62053 Page 4 http://www.WilTec.de http://www.aoyue.eu...
- Page 5 Soft steel 0.76 (0.30”) Stainless steel 0.58 (0.20”) Cold-rolled steel 0.60 (0.24”) Aluminium 1.39 (0.55”) Soft brass 1.16 (0.46”) Soft copper 1.16 (0.46”) Hard copper 0.86 (0.34”) © by WilTec Wildanger Technik GmbH Item 62053 Page 5 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
-
Page 6: Troubleshooting
(22) and adjust the po- sition of the setting block (35) by turn- ing the adjusting screw (33), re-tighten the knob (22). 2. Uncorrect lubricating 2. Lubricate correctly (s. “Lubricating”). © by WilTec Wildanger Technik GmbH Item 62053 Page 6 http://www.WilTec.de http://www.aoyue.eu 2021-1... - Page 7 58 Double flanging tool set 28 Gear unit 59 Wrench screw 29 Gear unit 60 Handle 30 Square plate 61 Handle bolt 31 M5 0.8×8 mm flat headed screw 62 Oil connection © by WilTec Wildanger Technik GmbH Item 62053 Page 7 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
- Page 8 Figure 3 Important notice: The reprint or reproduction, even of excerpts, and any commercial use, even in part of this instructions manual require the written permission of WilTec Wildanger Technik GmbH. © by WilTec Wildanger Technik GmbH Item 62053 Page 8 http://www.WilTec.de...