Table of Contents
Advertisement
Quick Links
User's manual
Hose reel
64158
Illustration similar, may vary depending on model
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Illustrations, functional steps, and technical data may deviate insignificantly due to continuous further
developments.
Updating the documentation
If you have suggestions for improvement or have found any irregularities, please contact us.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for WilTec XPOtool 64158
Summary of Contents for WilTec XPOtool 64158
- Page 1 User’s manual Hose reel 64158 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Illustrations, functional steps, and technical data may deviate insignificantly due to continuous further developments.
- Page 2 The information contained in this document may alter at any time without prior notice. No part of this document may be copied or otherwise duplicated without prior written consent. All rights reserved. WilTec Wildanger Technik GmbH cannot be held liable for any possible mistakes in this operating man- ual, nor in the diagrams and illustrations shown.
- Page 3 Introduction Thank you for choosing to purchase this quality product. To minimise the risk of injury, we ask you to always take some basic safety precautions when using this product. Please read this operating manual carefully and make sure that you understand it. Keep these operation instructions in a safe place.
- Page 4 Mounting Carefully take all pieces out of the box. Step 1: mounting the hose guiding system Determine the hose-guiding-system piece. 2. Set the hose-guiding-system piece into the tubes (see figure). Step 2: mounting the hand crank and water-system inlet Set the hand crank to the axle. 2.
- Page 5 Step 4: connect hose with reel Set the adaptor to the inlet and outlet water system. 2. Attach the C clamp to the ends of the hose connected to the inlet/outlet water system. 3. Guide the hose into the inlet/outlet water system, making sure that it penetrates deeply. Step 5: adjusting the stop ball The position of the stop ball can be adjusted to determine the length of the hose that stays outside the reel when the hose is reeled up.
- Page 6 • Clean the hose with mild soap and water only. Important note: Reproduction and any commercial use (of parts) of this operating manual, requires a written permission of WilTec Wildanger Technik GmbH. https://www.XPOtool.com Item 64158 Page 6...
Need help?
Do you have a question about the XPOtool 64158 and is the answer not in the manual?
Questions and answers