Safety Instructions - WilTec 61202 Operation Manual

Introduction
Thank you for purchasing this quality product. To minimize the risk of injury we urge that our cli-
ents take some basic safety precautions when using this device. Please read the operation in -
structions carefully and make sure you have understood its content.
Keep these operation instructions safe.

Safety Instructions

Perform a visual inspection of the device before each use. Do not use the device if parts are

damaged or worn. Never override safety mechanisms.
Consider the workspace environment. Protect the device from direct exposure to water.

Do not use power tools in humid or wet areas. Keep the working area well lit.

Do not use the tool with flammable liquids or gases.

Never use power tools in hazardous locations with paint, varnish, benzene, thinner, gases, ad-

hesives and other materials that are flammable or explosive. Power tools may produce sparks
during operation.
Protection against electric shock: Avoid physical contact with earthed surfaces, e.g. pipes, ra-

diators, cooker plates, refrigerators.
Keep children away. All visitors should be kept away from the work area.

Keep unused tools safe when not in use. Tools should be stored in dry and high or locked

place out of the reach of children.
Make sure that the electrical connections are protected from moisture and flooding.

Wear hearing protection and safety glasses to protect yourself whilst working. If you work on

objects creating dusts, please wear a dust mask.
Wear gloves to avoid losing control over the machine while working and using the insulated

handle surface.
Before working on the device or changing its equipment, switch the device off and pull the

plug.
Make sure that the cable does not come into contact with the moving parts and lead the cable

away from the machine.
Never operate the device if the power cable is damaged. Visually examine the device before

each use. If the cable seems damaged, it needs to be replaced by a qualified technician.
Ensure that ventilation slots always remain clean and open.

Wear protective shoes when working.

Only use the device for its intended purpose.

Avoid unintentional starting. Do not carry the tool with your finger on the switch. Do not carry

the tool by its cable either.
Clamp moving workpieces down before working, to avoid slipping.

Do not touch the drill immediately after it has run. The drill will be hot and may cause burns.

Always check that the bits are firmly placed before starting the device up.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Artikel 61202 Seite 3
09 2020-1