ResMed AirFit P10 User Manual page 10

connection. To inspect the vent, place a finger close to the connection
area and feel for air. Do not allow the venting area to become blocked.
Adjustment
To achieve a comfortable fit, adjust the upper and lower headgear bands -
spread bands apart to loosen or draw closer together to tighten.
If your headgear comes with AirFit P10 Headgear clips, you may use
these for additional adjustment. Refer to your Headgear clips instruction
sheet for assistance.
Note: The headgear with AirFit P10 Headgear clips may not be available
in all regions.
If your headgear comes with a buckle, adjust the headgear by pulling the
the headgear band through the buckle to fix mask leaks. Adjust only
enough for a comfortable seal and do not overtighten. You may need to
adjust the headgear as it stretches over time.
WARNING
Do not overtighten the headgear bands.
Removal
To take off your mask system, pull the mask and headgear by the split-
band, up and over your head.
Disassembly
1. Disconnect the mask tube from the vent module by gently twisting it
and pulling apart. If you are using the HumidX or HumidX Plus,
remove it from the vent module.
2. Disconnect the vent module from the AirMini tubing by gently twisting
it and pulling apart.
3. Holding the top of the mask tube, squeeze and pull the pillows away
from the mask frame.
4. Unhook the headgear from the stabilizer by pulling on the end cap to
reveal the buttonhole.
5. Slide the headgear off the end of the stabilizer.
4