Sleeve Intended use The AirFit N30i and AirFit P30i masks are intended to be used by patients weighing more than 66 lb (30 kg) who have been prescribed non-invasive positive airway pressure (PAP) therapy such as CPAP or bi-level therapy.
Fitting your mask 1. Pull the frame and headgear over your head until the elbow is positioned on top and the headgear is behind your head. 2. Place the cushion under your nose. For the AirFit P30i mask, align the pillows into your nostrils. 3.
Sizing the mask frame If the mask frame falls back over your head or sits too close to your ears, try a small frame size. If the mask falls forward on your head or sits too close to your eyes, try a standard frame size. Disassembling your mask for cleaning If your mask is connected to a device, disconnect the device air tubing from the mask elbow.
3. Thoroughly rinse the components under running water. 4. For the frame sleeves, squeeze with a clean towel to remove excess water. For the AirFit P30i mask, shake the QuietAir vent to remove any excess water. Leave the components to air dry out of direct sunlight.
• Do not iron the headgear as the material is heat sensitive and will be damaged. Technical specifications Compatible devices For a full list of compatible devices for this mask, see the Mask/Device Compatibility List at ResMed.com/downloads/masks. Pressure-flow curve: Pressure Flow...
Reprocessing the mask between patients Only Sleep Lab Mask (SLM) variants of the mask system are intended for multi-patient re-use. When using between patients, these masks must be reprocessed according to cleaning and disinfection instructions available on ResMed.com/downloads/masks.
7 days. This warranty is only available to the initial consumer. It is not transferable. If the product fails under conditions of normal use, ResMed will repair or replace, at its option, the defective product or any of its components. This limited warranty does not cover: a) any damage caused as a result of improper use, abuse, modification or alteration of the product;...