Samsung IER Series Installation Manual page 69

7. Settings / How to Use
7-1. PC-specific control software
LSM (LED Signage Manager)
• New Connection-Connect
1. If using an old version LSB, select "Without Cabinet IP."
2. If using a UHD LSB, select "With Cabinet IP (UHD)." Make
sure assigning a different IP address for each port connected
LED cabinets. Set the number of connected cabinets and click
"Connect."
3. If using an FHD LSB, select "With Cabinet IP (FHD)." Set the
IP addresses for the LED cabinets, and the number of
connected cabinets, and then click "Connect."
※ If IP addresses are already set for the cabinets, select the
"Connect with existing settings" checkbox.
※ If using UHD and some of the four ports will only be used, only
enter the IP addresses for the corresponding groups.
[★ Caution!] When configuring LED cabinet network settings, it is recommended
that a static IP address be used.
If DHCP is used and the IP address is changed, the connection with LSM may be
disconnected. The 192.168.10.x band is used for internal communication with LED
cabinets.
Use an IP address that does not belong to this band.
Use the IP address for LED (x4) assigned by your IT administrator. Do not assign
an IP address arbitrarily.
※ Should be different than S-Box / Should be different for each groups
※ Should be same as S-Box
68
LED R&D Lab(VD)