Samsung IER Series Installation Manual page 32

4. Frame Installation
Install the
ⓑ Bracket Middle.
③
※ First, check the holes into which to fix the ⓓ JIGs. (See Fig.1.)
※ Next, align the ⓓ JIG with the bracket holes and fasten the four screws. (See Fig.2.)
※ Lastly, fasten the screws to fix the ⓑ Bracket Middle to the wall. (See Fig.3.)
※ Caution: The surface ⓓ should be attached to ⓐ and ⓑ. The three surfaces (the wall,
ⓐ and ⓑ, and ⓓ) should be in parallel. (See Fig.4)
④ Use the same steps above to install all ⓑBracket Middle
in the left-to-right order.
※ Install the bracket center in the center of the frame kit.
※ When installing the Frame Kit, use a laser horizontal meter, thread, etc.
Install the horizontal/longitudinal vertical and horizontal planes while checking them.
※ Since the IER/IFR is far from the FRAME, more vertical horizontal
checks are needed.
Fig.1 Checking the holes
Fig.2 Fixing the Jigs
(with screws)
,
Fig.3 Fastening the screws
31
Incorrect
installation
Fig.4 Keeping frames parallel
a b c
b
d
Fig.5 Positions of components to attach
LED R&D Lab(VD)
Correct
installation
Wall
ⓐ,ⓑ,ⓒ
ⓓ
b a