Canon iR5000 Service Handbook page 209

E010
Main Cause The main motor (M2) is faulty. The DC controller PCB is faulty.
Mode of
Detection
0000 The clock pulses do not arrive for 2 secs or more after the main
E012
Main Cause The drum motor (M1) is faulty. The DC controller PCB is faulty.
Mode of
Detection
0000 The clock pulses do not arrive for 2 secs or more after the drum
E013
Main Cause The waste toner feedscrew is faulty. The water toner clock sensor (MSW2)
is faulty. The DC controller PCB is faulty.
Mode of
Detection
0000 The rotation of the waste toner feedscrew goes out of order, and
E014
Main Cause The fixing motor (M19) is faulty. The DC controller PCB is faulty.
Mode of
Detection
0000 The motor clock signal is detected for 2 secs or more continuously
E020
Main Cause The hopper connector is left disconnected. The hopper motor (M9/M10) is
faulty. The toner sensor (TS1/TS2) is faulty. The DC controller PCB is
faulty.
Mode of
Detection
0000 During printing, the toner supply signal is '0' (absence of toner) for
motor drive signal (MMFG) has been generated.
motor drive signal (DMFG) has been generated.
the switch (MSW2) is pressed multiple times during a specific pe-
riod of time.
after the fixing motor drive signal has been generated.
2 mins.
CHAPTER 5 SELF DIAGNOSIS
5-3