Connecting Headphones; Radio; Automatic Station Search (Ams); Storing Stations Automatically - Silvercrest SCUR 3 A1 Operating Instructions And Safety Instructions

Connecting headphones

♦ Turn the −VOL+/ І◄◄ TUNE ►►І dial
♦ Insert the jack plug on the headphones into the headphone socket
on the front of the device. Sound playback now takes place only via the
connected headphones.
♦ Set the desired volume with the −VOL+/ І◄◄ TUNE ►►І dial

Radio

Automatic station search (AMS)

NOTE
► This device must be switched on. Press the
if necessary, to switch on the device.
► The wire aerial
♦ Press the
display is shown on the display
♦ Press the ►/II/SCAN/AMS button
The station search works in both directions. This is dependent on the last-
used manual search direction. The station search stops at the next station
with a sufficiently strong signal.

Storing stations automatically

The automatic station search with station saving scans once through the entire
frequency band and automatically saves the first 20 stations with a sufficiently
strong signal in the programme spaces 1–20.
♦ Press the ►/II/SCAN/AMS button
the automatic station search with station saving. The first 20 stations will
be saved in the programme spaces 1–20 in order of increasing frequency.
After the station search is complete, the station stored in the first programme
space is played automatically.
NOTE
► The automatic station search replaces the stations already stored in the
programme spaces.

Manual station selection

♦ Press −VOL+/ І◄◄ TUNE ►►І dial
change the frequency in steps of 0.05 MHz. The current frequency is shown
on the display
♦ Press the −VOL+/ І◄◄ TUNE ►►І dial
GB │ MT
■ 42
│
must be unwound.
/SOURCE button
.
to the left to the lowest volume.
/SOURCE button
briefly until "FM" and the frequency
.
to start the automatic station search.
for longer than 2 seconds to start
once and turn it to the left or right to
again or wait at least 10 sec-
.
,
SCUR 3 A1