Clear The Call Queue, Disable Event Associated Calls; Operating On The Control Panel Network - INIM Electronics SmartLoop User Manual

View Events
The events represent the various conditions signaled by the panel and have the following order of
importance: alarm, pre-alarm, fault, early warning, bypass, test and monitor. The events that appear
on the control panel and Repeater displays may have been generated by other control panels in the
network.
If several events of the same type occur (e.g. three faults), only the first event will be shown on the
display. The system displays different real-time events in the order of importance (e.g.: if the system
is dealing with three fault events when a pre-alarm event occurs, the pre-alarm will take priority).
Control panel RESET operations clear all the events from the display, however, all events will be saved
to the log and can be viewed on the control panel.
2.4.1 Active Events
These are the events that occurred after the last control panel RESET operation.
Even t 001 of 003
PRE- ALARM
NORT H EAS T SEC TOR
Loop n°. 4 Po int 1 47
1 Main Menu
2 V iew L og
3 V iew p re-al arms
2.4.2 View Events Log
FROM PANEL
<any key>,
or <any key>,
The events are recorded in chronological order. Once the log is full, old events will be overwritten by
new ones. The navigation method is the same as that used for "Active Events".
2.5

Clear the call queue, disable event associated calls

FROM PANEL
<any key>,
or <any key>,
This command will allow you to clear the call queue, and enable/disable Alarm and Fault associated
calls.
1 Cl ear c all q ueue
2 Di sable s Ala rm ca lls
3 Di sable s Fau lt ca lls
2.6

Operating on the control panel network

FROM PANEL
<any key>,
op <any key>,
10
01/ 01/07 14:34 PM Fr i
W AREHO USE
CORR IDOR
Co ntrol pan el
1 View log
1
5 Communications
5
9 Remote Console
9
This is the first of three events. Press
keys and to view other active
events.
Press ESC to view the Events menu:
Press to select the menu option.
The option from menu 3 shows all the
events related to the selected event
type.
Select the required option.
Using the Control Panel
User Manual