Xerox Versant 4100 Press Quick Start Manual page 33

1. To access the feed components , pull out the tray slowly until it stops.
2. Replace the nudger roll:
a. Remove the nudger roll by pushing down on the black tab with one hand (which raises the
roll upward) and then squeezing the metal shaft on both ends with your other hand.
b. Lift out the nudger roll.
c. Install a new nudger roll by squeezing both ends of the metal shaft and while pushing down
on the black tab, insert and release the roll ends into the notches.
3. To access the separator roll, remove the separator roll assembly at the side of the tray:
Maintenance
Xerox ® Versant ® 4100 Press
Quick Start Guide
33