3Com 3C2000 User Manual page 30

7 Windows NT 4.0 Driver Installation
26
Verifying Successful Installation
To verify successful NIC installation:
1 Double click the My Computer icon, the Control Panel icon, and then the
Network icon.
2 Select the Adapters tab.
3 Make sure that the name of the NIC appears in the list of network adapters.
Modifying Configuration Parameters
To change configuration parameters in Windows NT 4.0, you must have the
3Com NIC Diagnostics program installed.
Although the default values should be appropriate in most cases, you may change
any of the available options to meet the requirements of your specific system.
1 Launch the 3Com NIC Diagnostics program.
2 Change the parameters as desired.
The following parameters are available (default values are listed in bold):
Parameter
Media Type
Flow Control
Log Status Messages
Boot ROM
Options
• AutoSelect
• 1000Full
• 100Full
• 100Half
• 10Full
• 10Half
• Hardware Default
• Disabled
• Asymmetrical Flow Control
• Symmetrical Flow Control
• Asymmetrical and Symmetrical
Flow Control
• Status Messages
• Warnings
• Errors
• None
• Disabled
• Enabled