3Com 3C2000 User Manual page 22

5 Windows Me Driver Installation
18
Modifying Configuration Parameters
Although the default values should be appropriate in most cases, you may change any
of the available options to meet the requirements of your specific system:
1 On the Windows Desktop, right-click the My Network Place icon and select
Properties.
The Network Configuration window appears.
2 Double-click the Gigabit Ethernet NIC you want to configure.
The Gigabit Ethernet Properties window appears, showing the Driver Type tab.
3 Click the Advanced tab.
A window showing the list of configurable parameters (and default values) for the
NIC appears.
4 Change the parameters as desired.
Click the options listed under Properties and then use the pull-down window under
Value to change the default or assigned value.
The following parameters are available (default values are listed in bold).
NOTE: These parameters and options are subject to change and may vary
from those listed in this user guide.
Parameter
802.1p Support:
FlowControl
Hardware Checksumming
Interrupt Moderation
Log Status Messages
Max IRQ per Sec
Maximum Frame Size
Option(s)
• Disable
• Enable
• Asymmetrical and Symmetrical
• Asymmetrical Flow Control
• No Flow Control
• Symmetrical Flow Control
• Off
• On
• Off
• On
• All Messages
• Errors
• None
• Status Messages
• Warnings
• 5000
• 1000 - 30000 (range)
• 1514
• 64 - 9014 (range)