Advertisement
Wi-Fi settings
If you use Wi-Fi function of the handset, you can use mail
or Internet by connecting to access points of your home,
corporate network or public wireless LAN service.
Radio interference with Bluetooth devices
z Wireless LANs (IEEE 802.11b/g/n) use the same
frequency band (2.4 GHz) as Bluetooth devices.
Therefore, using the wireless LAN device near a
Bluetooth device may cause radio interference,
lowering of communication speed, noise or
connection failure. In this case, turn off the Bluetooth
device or keep the handset and the wireless LAN
device at least approximately 10 m away from the
Bluetooth device.
z Packet communication is also available while [Wi-Fi] is
set to On. Wi-Fi connection is prioritized while Wi-Fi
connection is set, but the connection is automatically
switched to that of LTE/3G/GPRS network once Wi-Fi
connection is terminated. Note that packet
communication charges may be incurred in this case.
z Refer to the manual of your wireless LAN base unit
when using the access point at home etc.
z Operate access point registration near the access
point.
z If you use the docomo service by using Wi-Fi function,
set d ACCOUNT in advance. For details on d
ACCOUNT, refer to the DOCOMO website.
1
In the standby screen,
[Wi-Fi]
2
[Wi-Fi settings]▶Set to ON
3
Select an access point
z If you select an access point protected by security,
enter the password (security key) and select
[Connect].
z To register access points manually: z▶[Add
network]▶Enter the network name▶Set
[Save]
z WPS compatible access points can be easily
registered. In the standby screen,
[Wi-Fi]▶z▶[Easy Settings]▶[WPS Push Button]/
[WPS Pin Entry] to register an access point.
z If the access point you want to connect to is not
displayed: z▶[Refresh] to scan for access point
again.
When you select an access point and connect to it
z
with a wrong password (security key), [IP
Configuration Failure], [WiFi Connection Failure], or
[Authentication problem] is displayed. Confirm the
password (security key). When [IP Configuration
Failure] is displayed after entering the correct
password (security key), you may not have acquired
the correct IP address. Connect to the access point
again after confirming signal status.
73
z▶[Settings]▶
security▶
z▶[Settings]▶
Before Using the Handset
Advertisement
