Advertisement
Preferred network
„
P. 174"Preferred network mode"
Access Point
Names: For details
„
P. 144"Setting an access point"
Network
operators: For details
„
operators"
Setting an access point
„
An access point (sp-mode) for Internet connection is
registered by default. You can add other access points
and change them if necessary.
For details of sp-mode, refer to the NTT DOCOMO
website.
h ttps://www.nttdocomo.co.jp/service/spmode/ (in
(
Japanese
only))
If you want to use mopera U or Business mopera Internet,
add an access point of either provider manually.
For details on mopera U, refer to the mopera U website.
(
h ttps://www.mopera.net/ (in Japanese
Checking the access point that is currently used
1
In the standby screen,
[Network]▶[Network settings]▶[Cellular
networks]▶[Access Point Names]
Setting additional access points
z Never set the MCC to a figure other than 440 or the
MNC to a figure other than 10. Otherwise the added
access point disappears from the screen.
☞
mode: For details
☞
☞
P. 175"Network
only))
z▶[Settings]▶
1
In the standby screen,
[Network]▶[Network settings]▶[Cellular
networks]▶[Access Point Names]
2
z▶[New APN]
3
[Name]▶enter the name of the network
profile to create▶C
4
[APN]▶enter the access point name▶C
5
Enter other items required by network
operators▶z▶[Save]
If the settings of MCC and MNC are changed and the
z
added access point disappears from the screen, reset
the settings or set the access point manually.
Resetting an access point
„
Reset an access point to default setting.
1
In the standby screen,
[Network]▶[Network settings]▶[Cellular
networks]▶[Access Point Names]
2
z▶[Reset to default]
When sp-mode is not subscribed or if you fail to make
z
automatic setting of an access point due to signal
status such as outside the service area, you are
required to set the access point again manually.
144
z▶[Settings]▶
z▶[Settings]▶
Handset Settings
Advertisement
