Advertisement
Network operators
The handset searches available network to switch it
automatically by default setting. To switch network
manually, set in the following steps.
1
In the standby screen,
[Network]▶[Network settings]▶[Cellular
networks]▶[Network operators]
z When the confirmation screen is displayed for data
communication, check the content and select [OK].
z Search for networks and a list of network operators
is displayed.
z When an error occurs during the network search,
set [Data enabled] to [OFF] (
networks").
2
Select a network operator
z To search for network operators again: [Search
networks]
z To automatically select a network operator: [Select
automatically]
z▶[Settings]▶
☞
P. 143"Cellular
Date & time
If [Auto date & time] and [Auto timezone] of Date &
time are enabled, the handset receives information on
time and time differences from the network of a
connected overseas network operator, then time and
time differences are corrected.
z Time and time differences may not be adjusted
correctly depending on the network of an overseas
network operator. In this case, set time zone manually.
z The correction timing may differ depending on the
network operator.
z For details on Date & time
Inquiries
z When the handset or the docomo nano UIM card is lost
or stolen overseas, promptly contact DOCOMO and
conduct a procedure for canceling the use of service
from your country of stay. Refer to the last page for
inquiries. You can also cancel use of service from My
docomo. Note that call/communication charges after
the handset or the docomo nano UIM card is lost or
stolen are incurred to the subscriber.
z As for land-line phone etc., "International call access
number" of your country of stay or "Universal number
international prefix" is required.
175
☞
P. 148"Date & time"
International roaming
Advertisement
