Advertisement
Infrared communication
Receiving data
„
1
In the standby screen,
[Infrared]
2
[Receive]
3
Perform sending operation on sender's
device
4
Face the infrared ports of the receiver's
and sender's devices▶[OK]▶[Save]
Receiving all data
„
1
In the standby screen,
[Infrared]
2
[Receive all]
3
Enter the authentication password▶[OK]
4
Perform sending operation on sender's
device
5
Face the infrared ports of the receiver's
and sender's devices▶[OK]▶[Save]
z▶[Tools]▶
z▶[Tools]▶
After the operation for receiving, the handset waits to
z
receive data. Infrared communication automatically
begins when data is sent from sender's device within
approximately 60 seconds.
Note that if you select [Save] when receiving all data,
z
all data registered to the target function are deleted.
Receiving all data may not be available depending on
z
the data type.
When available space in the save destination
z
becomes insufficient while receiving data, the data
being received to that point are saved and receiving
ends.
Selecting data and sending
„
Example: Still picture
1
In the standby screen, z▶[Data]
2
Select a still picture
3
z▶[Send]▶[Infrared]
4
Perform receiving operation on receiver's
device
5
Face the infrared ports of the handset and
receiver's devices▶[OK]
159
Data communication
Advertisement
