Sharp Aquos SH-02K Instruction Manual page 189

z App does not work properly (cannot be activated or
error occurs)
y Is there disabled application? Try again after
enabling the disabled application.
P. 148"Enabling an app"
Calling
„
z Calls cannot be made by pressing key
y Make sure [Restrict calls] is not set.
P. 136"Restrict calls"
y Make sure Airplane mode is not set.
P. 141"Network"
y Make sure "Call restriction" is not set to "ON".
P. 91"Outgoing call settings"
z Ringtone does not sound
y Make sure In Calling in Volume is not set to "Silent".
☞
P. 133"Sound/vibration/notif."
y Make sure Public mode (power OFF), the manner
mode or Airplane mode is not activated.
P. 89"Network services", P. 133"Mode settings",
P. 141"Network"
y Make sure Set ring start time or Reject call setting
☞
is not set. P. 90"Incoming call settings",
P. 90"Reject call setting"
y Is Answer time setting set to "0sec"?
P. 88"Voice Memo/Answering Memo"
y Make sure the ringing time for Voicemail service or
Call forwarding service is not set to "0sec".
P. 89"Network services"
z Calls are not available ([
☞
☞
☞
☞
☞
„
z Main display is dark
☞
☞
187
after moving to another place or calls cannot be made/
received even though signal status is not bad)
y Turn the power on again or attach the battery pack
or docomo nano UIM card again.
nano UIM card", P. 59"Battery pack",
P. 64"Turning power on/off"
y Depending on the signal type, even though status is
"inside the service area" or "[
status) appears", making/receiving a call may not be
available. Move to another place and call again.
y Make sure the call restriction such as Reject call
☞
setting is not set.
y In a crowded place, heavy telephone/mail traffic may
make it difficult to get a connection depending on
how congested the radio waves are. In this case,
"Please wait for a while(voice call)" is displayed, and
a busy tone is played. Move to another place or call
again later.
Screen
y Make sure Screen timeout is not set to a short
☞
duration. P. 131"Wallpaper/display"
y Make sure the setting of Brightness is not changed.
☞
P. 132"Brightness"
y Make sure [VeilView] is not enabled.
P. 132"VeilView"
y Make sure [Energy saving] is not set.
P. 171"Energy Saving"
] does not disappear even
☞
P. 51"docomo
] (indicating signal
P. 90"Reject call setting"
☞
☞
Appendix/Index