AudioCodes Mediant 800 Reference Manual page 115

CHAPTER 7 SNMP Traps
Alarm
Critical HA feature has
failed to initialize Remote address
due to some not configured,
configuration No HA system."
error.
Remote address
Maintenance IF
address are not
subnet, No HA
Remote address
Maintenance IF
address should
be different, No
HA feature is
active, but the Reason = Fatal
system is not exception error"
operating in HA
mode.
WD exception
Reason = System
Reason = Eth link
- 106 -
Mediant 800 SBC | SNMP Reference Guide
acHASystemFaultAlarm
"SYS_HA: HA Need to configure a valid
'HA Remote Address'.
"SYS_HA: HA Need to configure a valid
Maintenance network
and interface and 'HA Remote
Address'.
on the same
system."
"SYS_HA: HA Need to configure a valid
Maintenance network
and interface and 'HA Remote
Address'.
HA system."
"Switch-Over: HA was lost due to
switchover and should
return automatically after a
few minutes. Corrective
action is not required.
"Switch-Over: HA was lost due to
Reason = SW switchover and should
return automatically after a
error" few minutes. Corrective
action is not required.
"Switch-Over: HA was lost due to
switchover caused by a
error" general system error and
should return automatically
after a few minutes.
Corrective action is not
required.
"Switch-Over: HA was lost due to
switchover. Reconnect the