Mounting The Intellijack - 3Com IntelliJack NJ225 User Manual

Mounting the IntelliJack

The IntelliJack mounts in any standard British Standard Institute (BSI): BS
4664:1970 cubicle opening or wall outlet.
Before connecting the IntelliJack to the network, verify that the existing network
cabling meets the ANSI/TIA/EIA-568 standard and that the port in the wiring closet
is connected to an active Ethernet MDI-X port.
1 Thread both IntelliJack LAN cables through the opening in the mounting plate.
2 Connect the wiring as illustrated in the previous diagram. The IntelliJack has two
Category 5 cables each terminated with a male RJ-45 connector.
The white cable connects the LAN to the four personal area network (PAN)
n
ports located on the bottom of the IntelliJack.
The black cable connects the LAN to the single pass-through port located
n
on the front of the IntelliJack.
3 Choose one pair of the provided screws that best fits your outlet box.
4 Tighten the screws while holding the IntelliJack in place.
NOTE: The IntelliJack is designed to be mounted using the provided mounting
plate or many after-market faceplates. However, some after-market faceplates
stand out from the wall and do not provide a secure mounting surface for the
IntelliJack. In such cases it is recommended to place the 3Com spacer between
the IntelliJack and the after-market face plate. For more information on the
different mounting plates and spacers, see page 4.
Installing the NJ225 11