Quectel EG91 Series Hardware Design page 13

❒ WCDMA II :≤8.000dBi
❒ WCDMA IV :≤5.000dBi
❒ WCDMA V :≤9.416dBi
❒ LTE Band 2 :≤8.000dBi
❒ LTE Band 4:≤5.000dBi
❒ LTE Band 5 :≤9.416dBi
❒ LTE Band 12 :≤8.734dBi
❒ LTE Band 13:≤9.173dBi
❒ LTE Band 25:≤8.000dBi
❒ LTE Band 26:≤9.416dBi
5. This module must not transmit simultaneously with any other antenna or transmitter
6. The host end product must include a user manual that clearly defines operating requirements and
conditions that must be observed to ensure compliance with current FCC RF exposure guidelines.
For portable devices, in addition to the conditions 3 through 6 described above, a separate approval is
required to satisfy the SAR requirements of FCC Part 2.1093
If the device is used for other equipment that separate approval is required for all other operating
configurations, including portable configurations with respect to 2.1093 and different antenna
configurations.
For this device, OEM integrators must be provided with labeling instructions of finished products.
Please refer to KDB784748 D01 v07, section 8. Page 6/7 last two paragraphs:
A certified modular has the option to use a permanently affixed label, or an electronic label. For a
permanently affixed label, the module must be labeled with an FCC ID - Section 2.926 (see 2.2
Certification (labeling requirements) above). The OEM manual must provide clear instructions
explaining to the OEM the labeling requirements, options and OEM user manual instructions that are
required (see next paragraph).
For a host using a certified modular with a standard fixed label, if (1) the module's FCC ID is not visible
when installed in the host, or (2) if the host is marketed so that end users do not have straightforward
EG91_Series_Hardware_Design
LTE Standard Module Series
EG91 Series Hardware Design
12 / 106