Encoder Control - Omron FS-C4KU7DGES-F Product Specifications And User's Manual

10.13

Encoder Control

The camera operation controls by Rotary Encoder.
GenICam Parameters
EcnoderSelector
EncoderSourceA
EncoderSourceB
EncoderMode
EncoderDiviber
EncoderOutputMode
EncoderStatus
EncoderTimeout
EncoderResetSource
EncoderResetActivation
EncoderReset
EncoderValue
EncoderValueAtReset
FS-C4KU7DGES-F / FS-C4KU7DGES-M42 / FS-C2KU7DGES-F / FS-C2KU7DGES-M42 / FS-C2KU7DGES-C
Product Specifications and Use's Guide
IEnumeration Selects Rotary Encoder.
Type Selection: Encoder0
Default: Encoder0
IEnumeration Selects input IO for A-phase of Rotary Encoder.
Type Selection: Off, Line0, Line1, Line2
Default: Off
IEnumeration Selects input IO for B-phase of Rotary Encoder
Type Selection: Off, Line0, Line1, Line2
Default: Off
IEnumeration Selects On / Off for jitter filtering for input encoder signal
Type Selection: FourPhase (with filtering), HighResolution (without filtering)
Default: FourPhase
IInteger Type Sets frequency division
Range: 1 to 65535
Default: 1
IEnumeration Selects output signal condition that how does target object move
Type Selection: Off,
Default: Off
IEnumeration Monitoring status of Rotary Encoder
Type
IFloat Type The TimeOut event is occurring when no input signal from Rotary
Encoder for specified period of time.
IEnumeration Selects signal for reset Rotary Encoder
Type Selection: Off, AcquisitionStart, FrameStart, Line0, Line1, Line2,
Default: Off
IEnumeration Selects signal condition for reset Rotary Encoder
Type Selection: RisingEdge, FallingEdge, AnyEdge, LevelHigh, LevelLow
Default: RisingEdge
ICommand Resets Rotary Encoder by software signal
Type
IInteger Reads or sets current position counter for Rotary Encoder
Type
IInteger Read the value of the position counter when reset Rotary Encoder
Type
PositionUP, PositionDown,
DirectionDown, Motion
SoftwareSignal0, SoftwareSignal1, LogicBlock0, Action0
No.20S046-00
DirectionUp,
42/62