Operation Of Remote Control Unit; Xd-8550/Xd-6000 (En/T - Kenwood XD-8550/8050 Instruction Manual

Operation of remote control unit

Loading batteries
1 Remove the cover.
Operation
Plug the power cord of the amplifier unit (A-H5) into a
power outlet and press the ON/STANDBY (
the remote control unit to turn power ON. When the power
is turned ON, press the desired operation keys.
To turn power off, press the
The system enters the standby mode in which only the
time display is lit.
When pressing more than one remote control keys successively,
press the keys securely by leaving an interval of 1 second or more
between keys.
1. The provided batteries are intended for use in operation checking, and their service life may be short.
2. When the remote controllable distance becomes short, replace both of the batteries with new ones.
Notes Notes
3. If direct sunlight or the light of a high- frequency fluorescent lamp (inverter type, etc.) is incident to the remote sensor, malfunction may occur.
In such a case, change the installation position to avoid malfunction.
2 Insert batteries.
Insert two R6 ("AA"-size) batteries
following the polarity indications.
) key of
(on/standby) key again.
3 Close the cover.
30
Model: RC-H7R
Infrared ray system

XD-8550/XD-6000 (En/T)

Remote sensor
6 m
30
Operating range (approx.)
1 9