Xd-8550/Xd-6000 (En/T - Kenwood XD-8550/8050 Instruction Manual

To end recording
1
REC / ARM
Pressing the key pauses recording after leaving a non-recorded
space of about 4 seconds.
If the key is pressed again in less than 4 seconds after it has been
pressed, recording resumes from that instant.
Recording can also be stopped by pressing the stop (7) key.
However, the non-recorded section is not left in this case.
2
To let recording pause temporarily
Press the REC/ARM key to resume recording.
AUX MD TAPE TUNER
Select an input source other than "TAPE".
Lights
REC / ARM
7
(Pause)
Lights
8
PAUSE
4. Select the source to be recorded.
Select the input source to be recorded.
CD
4 4
If you want to use one of "Convenient
recording functions", make preparation
Note Note
until this stage.
5. Start recording.
1 Start recording.
2 Play (or tune) the input source to be
recorded.
5 5
Selection of DOLBY NR
The Dolby NR system minimizes the hiss noise heard when
playing tape.
DOLBY NR
Each press switches the modes as follows.
1 "DOLBY NR indicator" ON
........ DOLBY NR is used.
2 "DOLBY NR indicator" OFF
........ DOLBY NR is not used.
Selection of the reverse mode
DOLBY NR
Each press switches the modes as follows.
1 "[" ... Both sides are recorded, and then the tape
stops (If direction 2 is selected, only the
back side of tape will be recorded.).
2 """ .. Both sides are recorded (If direction 2 is
selected, only the back side of tape will be
recorded.).
3 """ .. Only one side is played back (recorded),
and then the tape stops.
When the CD input is selected and if a disc
has been set in the CD player, its playback
p
starts immediately. Press the stop (7) key to
stop the playback.
Recording stops automatically when the tape
side(s) to be recorded have been fully re-
corded.
When the recorded sound level is too low or too high causing
distortion, it is possible to adjust the recording level manually.
Let's record

XD-8550/XD-6000 (En/T)

(Noise Reduction)
REV.MODE
REV.MODE
Lights up
(when CD input is selected)
UNER CD
›
3 3