Operation Of Remote Control Unit - Kenwood XD-A83 Instruction Manual

Operation of remote control unit

14
Loading batteries
1 Remove the cover.
Operation
Plug the power cord into the mains power outlet and
press the on/standby
control unit to turn power ON. After the power has been
turned ON, press the desired key.
To turn power off, press the
again.
The power mode enters the STANDBY mode in which
the "STANDBY" indicator lights up. (The "TIMER" in-
dicator also lights in this mode if a timer program has
been activated.)
When pressing more than one remote control key suc-
cessively, press the keys securely by leaving an interval
of 1 second or more between the key presses.
1.The provided batteries are intended for use in operation checking, and their service life may be short.
2.When the remote controllable distance becomes short, replace both of the batteries with new ones.
Notes Notes
Notes
3.If direct sunlight or the light of a high- frequency fluorescent lamp (inverter type, etc.) is incident to the remote
sensor, malfunction may occur. In such a case, change the installation position to avoid malfunction.
2 Insert batteries.
Insert two R6 ("AA"-size) batteries
following the polarity indications.
( POWER) key of the remote
on/standby( POWER) key
3 Close the cover.
2
Operating range
(approx.)
6m
30
˚
1
Remote
sensor
30
˚